3
Power switch
Direction switch (IN/OUT)
NEW!
XRC Gen3 Winch
Remote Controller Features
Load Indicator
Power IN
switch
To power IN:
Press the power IN
switch. The switch
cover and IN indica-
tor will light up. Use
the power switch to
control the winch.
Note: If you press
the power IN switch
a second time, the
remote will go into
neutral and will not
power the winch.
Power IN
indicator light
Power OUT
switch
To power OUT:
Press the power OUT
switch. The switch
cover and IN indica-
tor will light up. Use
the power switch to
control the winch.
Note: If you press the
power OUT switch
a second time, the
remote will go into
neutral and will not
power the winch.
Power OUT
indicator light
What do the
colored lights
on the Load
Indicator mean?
COLOR: BLUE
READY
Winch is ready to start
COLOR: GREEN
LOADING
Winch is operating within
safe levels
COLOR: YELLOW
MAX LOAD
Winch is operating at
maximum load
COLOR: RED
OVERLOAD
STOP!!!
Time to use snatch
block or other assist
IMPORTANT: Load indicator lights will let you know approximately how much load is on your winch based on the
chart above. Maximum pulling power is only achieved when pulling from the first layer of rope on the drum. Avoid
continuous winching at high load and always check motor temperature frequently. If motor is too hot to touch , allow
to cool before you continue your recovery. It is recommended to re-access your recovery and consider the use of a
snatch block when recovery exceeds full load and/or when red over load lights begin to light up.
Summary of Contents for 97612
Page 1: ...1 XRC GEN3 INSTRUCTION MANUAL ...
Page 9: ...9 INSTALLATION INSTRUCTIONS ...
Page 13: ...13 Armor Plate Removal ...
Page 24: ......
