For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
(Part # Q89)
Dual Cylinder Air Compressor
WWW.SMITTYBILT.COM
Operation:
When operating the unit, be sure to be in a safe location off of the roadway and away from traffic.
Step One:
Unpack the unit and inspect for damage. Fully unwrap the power cord.
Step Two:
Place the unit on a dry level surface. Attach the air filter to the front of the unit and finger
tighten.
Step Three:
Connect the air supply hose to the unit using the quick connect fitting.
Fig #1. Slide retaining snap ring back.
Fig #2. Slide the fittings together firmly.
Fig #3. While holding fittings together firmly slide the outer ring forward to lock.
Fig #1
Fig #2
Fig #3
Step Four:
Connect the Red power clip to a Positive 12 volt source.
Connect the Black power clip to a Negative ground point.
Step Five:
Test the connections by switching the compressor to “on.” Air will begin to flow.
Step Six:
Connect the air hose by screwing the brass inflator onto the tire valve stem. Only finger tighten
the inflator. Do not use any tool as you may damage the inflator or the valve stem.
Step Seven:
Watch the gauge closely, switch the unit off or remove the inflator from the tire when the
manufacturer’s recommended pressure has been achieved. We recommend that you use a
second tire pressure gauge to verify your tires are inflated to the proper pressure.
CAUTION:
Stopping and restarting at high pressure can overload and blow the in-line fuse. At higher
inflation pressures, start the unit and then attach to the filler to the tire valve stem. If you stop the unit and
need to resume inflation, remove the inflator tip from the tire valve, start the unit and reattach with the unit
running.