Assembly (Cont)
5. Set the Sprayer unit on top of the container by guiding
the inlet tube into the hole in top of container.
6. Set the Power Switch to the off position
7. Insert the Battery into the receptacle, DO NOT FORCE.
When properly aligned it will slide in easily. When fully
inserted it will contact the Sprayer housing and you will
hear a click indicating the Safety Switch has been
activated.
8. Check the sprayer trigger handle to make sure the
lever is not locked in the open/ on position.
9. Turn the Speed Control to Hi (fast) by turning
completely clockwise. It is located on the top front of the
Sprayer, next to the Power Switch.
Page 9
SMK shall in no event be liable for death, injuries to
persons or property or for incidental, contingent, special or
consequential damages of any kind by the reason of use or
sale of any defective product or part. This limited warranty
covers units distributed in the United States of America
only.
This limited warranty is in lieu of all other warranties,
expressed or implied, and no other person is authorized to
give any other warranty or assume obligation or liability on
behalf of SMK Industries, Inc.
Products and parts must be flushed free of all fluids prior to
returning to SMK for warranty inspection.
PROOF OF PURCHASE
Please retain your dated sales receipt as proof of purchase
to validate the warranty period.
SPECIFICATIONS
Pump
TOPSFLO®
MG213XK/DC24WI
Pump Voltage
24 Volts
Chassis
Powder Coated Steel
Spray Gun
TeeJet
®
AA30L-1/4
Wand
TeeJet
®
6671-24
Wand tips
TeeJet
®
XR8001-VS, 5500-X8
Approved batteries
Dewalt
®
18V
or
Interstate
®
18V
Flow Rate
1.0 GPM (free flow)
Battery Life
30 Gallon Minimum (w/cone tip)
Pressure
60 PSI up to 0.8 GPM
Page 6
