SMOKE-FACTORY –
DATA II
Operating Instructions
Pressing the Enter button will bring you back to the standard menue where you start the
programming.
Pressing the enter button during the programming in
Timer-menues
will start the cycle with
the last time shown on the display.
(P.xx = Starts with wait time, F.xx = Starts with fog time).
You can switch back to the Standard-Menu by pressing the Mode-button for more than 2 seconds or by
switching to „ESC” (Escape) in the Timer-Mode and then press the Enter-button.
5.5
Autostart
If the timer is in operation and you disconnect the machine from the mains cable, the
DATA II
will re-
start in the Timer-Mode as soon as it‘s reconnected to the mains. To stop this press the Mode-button
for more than 2 seconds or by switching to „ESC“ in the Timer-Mode and then press the Enter-button.
6 Cleaning, care and maintenance
•
Ensure the air vents are not clogged by dust. If necessary remove the dust.
•
Take care that the machine can not get overheated.
•
Do not run the
DATA II
without any fluid, as the pump will run dry.
•
Wipe up spiled Fluid immediately. Moisture – also fluid – can destroy the electric
of the machine.
•
Check the state of the air valve filter from time to time and clean or replace it when necessary.
When frequently using the same fluid can it should be cleaned thoroughly before adding new
fluid. This reduces the chances of the machine clogging up.
•
If you install the
DATA II
make 100% shure that a permanent fog-free air supply for the unit is
guaranteed. Cooling air with too high fog concentration very often in Clubs and Discos) can
condense inside the machine and cause moisture damage.
•
For cleaning the surface the device use a suitable, solvent-free cleaner.
•
The differens between DATA II/pump and fluid bottle shut not mor than 1,5m
.
SMOKE FACTORY
issue 1.0 Page: 12 of. 15
FOG GENERATORS NEBELMASCHINEN
