6 How to Ride and Stop
1. Press the power button and hold for 2
seconds to turn on the scooter. Check the
power indicator.
2.Step on the deck with one foot, and
slowly kick off the other on the ground.
3.When the scooter starts to coast, put both
feet on the deck and push down the
accelerator.
NOTE: Do not push down the accelerator
before the scooter reach the speed 3 mph,
the scooter must be traveling at least 3 mph
before motor will engage.
5. For controlled stops, release the throttle
and apply the brake by putting pressure on
the rear-fender brake.
4. Tilt your body to the steering direction
as you turn, and slowly turn the handlebar.
Always wear proper protective equipment,
such as an approved safety helmet (with
chin strap securely buckled), elbow pads,
and kneepads. A helmet may be legally
required by local law or regulation in your
area. A long-sleeved shirt, and long pants
are recommended. Always wear shoes and
keep shoelaces tied andout of the way of
the wheels and motor. Never ride
barefooted or in sandals.
09
10
