12
6.75 TREADMILL
MAINTENANCE
To apply lubricant to the walking belt
:
1. Position the walking belt so that the seam is located on top and in center of the walking board.
2. Insert the nozzle of the lubricant container under the belt
3. While lifting the side of the walking belt, position the nozzle between the walking belt and the board
approximately 15 cm (6 inches) from the front of the treadmill. Apply the silicone lubricant to the walking
board, moving from the front of the treadmill to the rear. Repeat this on the other side of the belt. Spray
approximately 2 seconds on each side. Note: it is important to get the lubricant as far to the center of the
walking board as possible.
4. Allow the silicone to "set" for 1 minute before using the treadmill.
Apply lubricant from front to back.
CLEANING
:
Routine cleaning of your treadmill will extend the product's life.
Warning
: To prevent electrical shock, be sure the power to the treadmill is OFF and the power cord is unplugged
from the wall electrical outlet before attempting any cleaning or maintenance.
Important
: Never use abrasives or solvents to clean the treadmill. To prevent damage to the computer, keep
liquids away and keep it out of direct sunlight.
After each workout
: Wipe off the console and other treadmill surfaces with a clean, water dampened soft cloth to
remove excess perspiration.
Weekly
: Use of a treadmill mat is recommended for ease of cleaning. Dirt from your shoes contacts the belt and
eventually makes it to underneath the treadmill. Vacuum underneath treadmill once a week.
Silicone Icon
FIG1
Maintenance Icon
FIG2
Note: when lubricating the belt, make sure the treadmill is located on a surface that can be easily cleaned.
After lubricating your treadmill running belt, clean any excess silicone off the belt and frame.
The silicone icon in Figure 1 will turn on in the display every 100 hours of use and is a
reminder that it is time to lubricate the running belt. As indicated above, it is best to
lubricate the running belt every 50 hours of use. This is a reminder for the 2
nd
50 hours.
The icon will be in the display for 5 minutes and then it will turn off. To turn the icon
off, you can simply press the “Speed down” and “Incline down” buttons simultaneously
until the icon goes off.
After cleaning and checking all assembly hardware, to turn the maintenance icon off,
press the “Speed down” and “Incline down” buttons simultaneously until the icon turns
off. Note: If you do not use combined buttons “Speed down” and “Incline down” to
reset, the console will display maintenance caution for 1 minute after turning on the
treadmill. If you reset it by using combined buttons “Speed down” and “Incline down,”
then the caution will not be displayed after turning on the treadmill
.
