www.smoothfitness.com
29
MOTION CONTROL OPERATION
MOTION CONTROL
:
Walking belt speed can be increased, decreased or stopped using the Motion
Control sensors on the handlebars. To do this follow the instructions below:
1.
Press the
button on the console to switch the motion control
function on and off:
•
When the LED light is
ON
the MOTION CONTROL is
active
.
•
When the LED light is
OFF
the MOTION CONTROL is
off
.
2.
After switching on the MOTION CONTROL wave your right hand
approximately 6 inches above the motion sensor on the right handle
bar to increase the speed. The sensor will sound one short BEEP
per scan and speed up by 0.1 MPH per BEEP. Holding your right
hand approximately 6 inches above the right sensor constantly
results in the sensor sounding one long BEEP per second and
speeding up by 0.5 MPH per second.
2.
Use right sensor to speed up.
3.
Wave you left hand approximately 6 inches above the motion sensor
on the left handle bar to decrease the speed. The sensor will sound
one short BEEP per scan and decrease speed by 0.1 MPH. Holding
your left hand approximately 6 inches above the left sensor
constantly results in the sensor sounding one long BEEP per second
and decreasing speed by 0.5 MPH per second.
3.
Use left sensor to slow down.
4.
Wave both hands approximately 6 inches above both motion
sensors at the same time. The sensor will sound two short BEEP
sounds then stop the belt.
•
Always switch off the motion control function by pressing the
MOTION CONTROL button on the console before turning
off the power to the treadmill.
4.
Use both sensors to stop belt.
Summary of Contents for 9.45ST
Page 11: ...www smoothfitness com 11 PARTS DIAGRAM MOST OF THE PARTS SHOWN HERE HAVE BEEN PRE ASSEMBLED ...
Page 12: ...12 9 45ST TREADMILL PARTS DIAGRAM MOST OF THE PARTS SHOWN HERE HAVE BEEN PRE ASSEMBLED ...
Page 14: ...14 9 45ST TREADMILL PARTS DIAGRAM MOST OF THE PARTS SHOWN HERE HAVE BEEN PRE ASSEMBLED ...
