16
935i TREADMILL
ASSEMBLY
STEP 2
:
Attach the Console Mast to the Base Frame.
NOTE: Make sure all wires are recessed into the frame. DO NOT trap or
pinch the wires. DO NOT tighten any bolts until STEP4.
Before attaching the
Right
upright (301) first wrap the fish wire (preinstalled from
the factory in the right upright) to the computer data wire located on the base
frame.fish wire in the upright. This will allow you to pull the data cable up through
the upright during installation.
1). Attach Left and Right Uprights into base frame, and secure using the 8 x
M8x15mm Bolt (303) with 8 x M8 Washer (305).
303
X8
305
X8
Caution Pinch point! Do not pinch wires between frame.
303
305
Green plastic wrap
Clear plastic wrap
Fish wire
Computer wire
location
Feed the computer
wire through the
upright tube
Do not tighten bolts until step 3
Summary of Contents for 935
Page 12: ...12 935i TREADMILL PARTS DIAGRAM MOST OF THE PARTS SHOWN HERE HAVE BEEN PRE ASSEMBLED ...
Page 13: ...www smoothfitness com 13 PARTS DIAGRAM MOST OF THE PARTS SHOWN HERE HAVE BEEN PRE ASSEMBLED ...
Page 41: ...www smoothfitness com 41 HANDLE BUTTONS Handle buttons Incline button Speed button ...