29
“
C
ONSOLE
I
NSTRUCTIONS
–
U
SER
S
ETTING
P
ROGRAM (P13 ~ P16)
”
TO ENTER TIME:
UP
or
DOWN
button:
e. After entering the
User Program
the
TIME
function
mode will appear with the display flashing
“0:00”.
f.
Use
UP
or
DOWN
buttons to set the desired
TIME
Press enter to confirm
(1:00 TO 99:00; 1 MINUTE
INCREMENTS)
NOTE for TIME:
Count Up: If a target time was not selected,
TIME
will count up from 0:00 to maximum 99:59 minutes
Count Down: If you have set the target time, the
console will count down from that selected target
time down to 0:00
TO ENTER DISTANCE:
ENTER
button and then
UP
or
DOWN
button:
a.
After entering the
User Program
the
TIME
function
mode will appear with the display flashing
“0:00”.
b.
Press the
ENTER
button again, the
DISTANCE
function mode will then appear with the display flashing
“0.0”
c.
Use
UP
or
DOWN
buttons to set the desired
DISTANCE.
Press enter to confirm
(1 TO
999KM/MILE; 1 KM/MILE
INCREMENTS)
NOTE for DISTANCE:
Count Up: If a target distance was not selected, this
would measure the total distance from 0:00 to 999
km/mile
Count Down: If you have set the target distance, the
console will count down from the selected target
time down to 0
C. SET CALORIES and AGE
”
3. Calories
:
a. After confirming the
TIME
or
DISTANCE
b. Use
UP
or
DOWN
buttons to set the desired
CALORIES
press enter to confirm
(10 TO
9990KCAL; 10 KCAL
INCREMENT)
NOTE for CALORIES:
Count Up: If target calories was not selected, this would measure total calories burned during exercise
Count Down: If you have set the preference value of calories, the console will count down from that selected value
down to 0
4.
Age Selection
a. Press
ENTER
button to confirm the
CALORIES
value and enter the mode to set the
AGE
b. Use
UP
or
DOWN
buttons to set your
AGE
. Press
ENTER
to confirm
(10 TO 99 YEARS
OLD; 1 YEAR OLD INCREMENT) Press enter to confirm.
NOTE
:
Although the console allows input for age beginning at 10 years old, the product is not recommended for
use by children
Summary of Contents for CE-3.0DS
Page 37: ...36 PRODUCT PARTS DRAWING...
