FX60HRO MOTORIZED TREADMILL
Visit us at:
www.evofitness.com
20
STABILIZER ADJUSTMENT
How to level the treadmill
:
An uneven floor or improper stabilizer level can cause the treadmill to wobble during use as well as the incline
adjustment to function incorrectly. Please follow the procedure described below to make sure the treadmill stabilizer
is adjusted correctly prior to use. You may need the assistance of another person to perform this adjustment.
1.
To perform the stabilizer adjustment you first
need to bring the treadmill to the highest incline
level as shown in drawing
1
. After you’ve
completed the assembly procedure plug in the
power cord and switch on the POWER
SWITCH. Insert the Safety Key and press the
START button to quick start the treadmill. Press
the INCLINE UP button until the deck reaches
its highest incline level. Now press the STOP
button and pull out the Safety Key. Switch off
the POWER SWITCH and unplug the power
cord.
1.
Raise deck to highest incline level.
2.
Inspect the two stabilizers (one per side) located
underneath the base frame. The treadmill
should sit on the floor with both stabilizers and
all four cushions resting firmly on the floor as
shown in drawing
2
. Shake the handlebars
back and forth to check if they are resting firmly
on the floor. If they are not, pull the handlebar
backward to adjust the stabilizers as shown in
drawing
3
. Simply turn the stabilizers like a
screw to adjust their heights. Repeat this until
the treadmill sits firmly on the floor.
2.
Check position of stabilizers and cushions.
3.
Tilt treadmill to access stabilizers.