FX60HRO MOTORIZED TREADMILL
Visit us at:
www.evofitness.com
23
MAINTENANCE
To apply lubricant to the walking belt
:
1. Position the walking belt so that the seam is located on top and in center of the walking board.
2. Insert the spray nozzle into the spray head of the lubricant can.
3. While lifting the side of the walking belt, position the spray nozzle between the walking belt and the board
approximately 15 cm (6 inches) from the front of the treadmill. Apply the silicone spray to the walking board,
moving from the front of the treadmill to the rear. Repeat this on the other side of the belt. Spray
approximately 4 seconds on each side.
4. Allow the silicone to "set" for 1 minute before using the treadmill.
Spray lubricant from front to back.
CLEANING
:
Routine cleaning of your treadmill will extend the product's life.
•
Warning
: To prevent electrical shock, be sure the power to the treadmill is OFF and the power cord is
unplugged from the wall electrical outlet before attempting any cleaning or maintenance.
•
Important
: Never use abrasives or solvents to clean the treadmill. To prevent damage to the computer,
keep liquids away and keep it out of direct sunlight.
•
After each workout
: Wipe off the console and other treadmill surfaces with a clean, water dampened soft
cloth to remove excess perspiration.
•
Weekly
: Use of a treadmill mat is recommended for ease of cleaning. Dirt from your shoes contacts the
belt and eventually makes it to underneath the treadmill. Vacuum underneath treadmill once a week.