10
“
A
SSEMBLY
I
NSTRUCTIONS
”
S
TEP6
–
Seat Assembly
1. For ease of assembly, turn the seat upside
down and place it on the floor or any flat
surface.
2. Line up the holes in the seat post with the
threaded holes on the seat.
3. Secure the seat post to the seat using 3 x #3
bolts (M8*13mm).
4. Tighten all bolts now.
5. Align the transportation handle screw holes
with the two screw holes on the bottom of
the seat towards the rear.
6. Secure the handle to the seat using 2 x #3
bolts (M8*13mm).
#3 x 5
S
TEP7
–
Seat Installation
1. To insert the seat, turn the adjustment knob
counter clockwise to loosen.
2. Pull the knob outward and insert the seat at
the same time, until the seat post is fully
inserted and the seat rests on the plastic
cover.
3. Release the knob and slowly pull up on the
seat until it locks in place.
4. After releasing the pin and the seat is locked
in place, verify that the seat will not move up
or down.
5. Tighten the knob by turning it clockwise until
it is completely tight
.
Note: Do not completely remove the
adjustment knob from the frame. To
adjust the seat you will need to loosen the
knob and then pull the knob outward.
Pull
Summary of Contents for sit N cycle SNC-II
Page 13: ...13 Exploded Diagram...