8
“
A
SSEMBLY
I
NSTRUCTIONS
”
S
TEP3
–
Seat Installation and Handlebar Assembly
1.
Insert the seat adjustment knob into the
mainframe by turning the knob 5 times
clockwise.
2. After threading the adjustment knob in to
the mainframe, pull the knob outward
while inserting the seat post into the
mainframe.
3. Once the seat is at the preferred height,
release the knob and slide the seat
downward until the seat locks in place.
4. Confirm that the seat is locked in place
by lifting upward on the seat verifying that
is does not move upward.
5. Turn the knob clockwise until the knob is
completely tight.
Seat Adjuster
Knob
1. Place the seat handlebars onto the
handlebar mounting bracket and align the
two holes on the handlebar with the two
holes on the handlebar bracket.
Note: Make sure the handlebar is facing forward
as pictured on the left
2. Secure the handlebar to the bracket using
2x M8*55mm bolts(15), 2x M8 spring
washers(19) and 2x M8 flat washers(22)
3. Completely tighten all fasteners now
2x #19
2x #22
2x #15
Summary of Contents for SMB-XBIKE
Page 16: ...16 EXPLODED DIAGRAM...
