10
UB4 Upright Bike
www.smoothfitness.co.uk
ASSEMBLY - INSTRUCTIONS
Step 5 -
Install Computer
Connect the Upper Computer Wire (47) and Hand
Pulse Wire (48) to the 2 wires
that are on the back of the computer (15).
Attach the Computer to the Handlebar post ( 2) Using
4 – M5 x 10MM Screws (125) ( On back of
Computer)
Note: Be careful not to damage or disconnect the
wires when attaching the computer.
Step 6 -
Install Seat
Attach Seat ( 14 ) to Seat post ( 03 ) using:
3 – M8 Flat Washer ( 88 )
3 – M8 Nyloc Nut ( 66 )
Step 7 –
Install Pedals and Pedal Straps
Thread Right Pedal (8R) with an “R” onto the Right
Crank Arm ( 7 ) in a clockwise direction.
Thread Left Pedal (8L) with an “L” onto the Left
Crank Arm ( 7 ) in a counter–clockwise direction.
Step 8 –
Plug the AC Adaptor
Plug the AC adaptor lead ( 95 ) into the socket at the
rear end of your
Upright Bike as shown.
Plug the 6V 1000mA A.C. Adaptor into a suitable
mains supply.
