16
“
O
PERATION
I
NSTRUCTIONS
”
HOW TO CHANGE THE WLLIPTICAL BIKE MOTION
STEP MODE:
The item can be used in the
ELLIPTICAL
mode or the
STEP
mode.
Refer to the following process to set up the
ELLIPTICAL
mode or the
STEP
mode.
a. Before exchanging the
ELLIPTICAL
mode with the
STEP
mode, make sure the SIDE YOU ARE ADJUSTING IS IN
the lowest position as the figure shows below
b. Remove the
Locking Knob (68)
from the
Right Pivoting Arm (13)
c. Attach the
Right Pedal Linkage (19)
to the
Rear Stabilizer (8)
and fully tighten the
Locking Knob (68)
d. Repeat the above process on the left side
CAUTION
: Make sure both
Locking Knobs (68)
are tightened before exercising
ELLIPTICAL MODE:
Summary of Contents for V2300
Page 24: ...24 PRODUCT PARTS DRAWING A ...
Page 25: ...25 PRODUCT PARTS DRAWING B ...