9
“
A
SSEMBLY
I
NSTRUCTIONS
”
S
TEP
7
–
Pedal Support Arm
Assembly
a. Refer to the inset drawing
FIG .2
: Cut off
the
tie wrap (A)
on the front end of the
Right Pedal Support Arm (14)
.
NOTE:
Please be sure that the
Shaft Sleeve (68)
inside the
Pedal Support Arm (14)
does
not fall out while cutting off the tie.
b. Attach the front end of the
Right Pedal
Support Arm Assembly (14)
to the
Right
Pivoting Arm (12)
with the 1pc
Bolt
(M8xp1.25x90mm)(106)
and 1pc
Nut
(M8xp1.25)(112) NOTE:
Confirm that
Bolt
(106)
will slide through the
Shaft Sleeve
(68)
inside front end of the
Right Pedal
Support Arm Assembly (14)
during
assembly.
NOTE:
Refer to the
inset drawing
FIG.3
:
For shipping
purposes, the1pc
Roller Spacer (56)
,
1pc
Bolt
(M8xp1.25x65mm)
(105)
, 1pc
Nylon Nut (M8xp1.25)(112)
are
preinstalled on the
Right Roller Bracket (69)
as pictured on the right.
c. Remove the 1pc
Roller Spacer (56)
, 1pc
Bolt (M8xp1.25x65mm)(105)
, 1pc
Nylon Nut (M8xp1.25)(112)
from the
Right Roller Bracket (69).
d. Refer to
FIG 3
. Place the
Right Pedal Support Arm (14)
onto the
Right
Sliding Rail (5) Lining up the
groove of the Pedal Support Arm Roller with the Sliding Rail
.
e. Then place the
Roller Spacer (56)
through the
Roller Bracket (69)
and under the
Right Sliding Rail (5)
,
secure the 1pcs
Bolt (M8xp1.25x65mm)(105)
through the
Roller Spacer (56)
with
the1pcs
Nylon Nut
(M8xp1.25)(112)
.
NOTE:
Please be sure not to over-tighten the
Bolt (105)
and
Nut (112)
, after tightening,
make sure the
Roller Spacer (56)
will still rotate slightly. Use your finger to rotate the
Roller Spacer (56)
.
If the
Roller Spacer (56)
is unable to rotate, it may cause the roller to run roughly on the Sliding Rail.
Loosen the nut and bolt slightly if necessary.
f. Repeat the process above for the left side.
S
TEP
8
–
Pedal Assembly
a. Attach the
Pedal Bottom Cover (130)
to the
Right Pedal (54)
and secure it with the 3pcs
Flat Head Self-Tapping
Screws (M4x10mm) (131).
b. Attach the
Right Pedal (54)
to the upper
Pedal Plate
located on the rear of the
Right Pedal Support Arm (14)
and
secure it with the 2pcs
Lock Washers (M8)(79)
and 2 pcs
Bolts (M8xp1.25x16mm)(94)
.
c. Repeat the process above for the left side.
FIG. 3
FIG. 2
Summary of Contents for VT-3.4
Page 40: ...40 PRODUCT PARTS DRAWING A...
Page 41: ...41 PRODUCT PARTS DRAWING B...
Page 45: ...45...
