20
21
PROBLEM
SOLUTION
The Activation Button Lights on the handset do not light up when
placed against your skin.
Make sure the power supply is plugged in. Ensure the Skin Tone
Sensor is fully pressed against the skin. Your skin could be too dark
for treatment. Check against the skin tone chart in the front of this
user guide.
The Activation Button on the handset lights up white when placed
on the skin, but the handset fails to flash when the Activation button
is pressed.
There could be a fault with the device. Unplug the device and
restart. If the problem persists, visit the website for support details.
The Activation Button Lights on the handset are illuminated red
continuously, and the device will not function.
This indicates that there is a fault with the device. Stop using the
device and visit the website for support details.
The SMOOTHSKIN handset, treatment window, power supply or
cable are damaged, broken, cracked or appear defective.
DO NOT USE.
If you are in any doubt about the safety of
SMOOTHSKIN BARE+ or suspect it is damaged in any way, it must not
be used, and you should vist the website for support details.
6.1 TECHNICAL SPECIFICATIONS
SMOOTHSKIN BARE+ is a filtered broadband Intense Pulsed Light system with the following
technical specifications:
•
Repetition Rate:
Manually pulsed every 0.6 seconds
•
Continuous Operation
•
Max Optical Output:
3J/cm
2
•
Pulse Length:
1msec FWHM
•
Wavelength:
510-1100nm
•
Power Line Input:
100–240V~, 50/60Hz, 1.7-0.91A
•
Operating Temperature:
Between 5°C and 40°C
•
Operating Humidity:
Up to 93%R.H. non condensing
•
Operating Pressures:
700hPa to 1060hPa
•
Treatment Area (spot size):
3 cm
2
(30mm x 10mm)
Transport Conditions:
•
Temperature:
-25°C to +70°C
•
Humidity:
Up to 93%R.H. non condensing
•
Pressures:
500hPa to 1060hPa
SMOOTHSKIN BARE+ has unlimited flashes and is intended for a single user.
CE marking certifies that this appliance conforms to the following EEC directives:
•
Low Voltage Directive 2014/35/EU
•
Electromagnetic Compatibility Directive 2014/30/EU
•
Energy related Product Directive 2009 / 125 / EC.
6.0 INFORMATION
To ensure maximum performance of your SMOOTHSKIN BARE+, it is particularly important to keep the reflector
and
skin tone sensor
free from
dirt, hair or other debris. If necessary, the
reflector
and
skin tone sensor can be carefully cleaned by using a slightly damp cotton bud.
3.
Store SMOOTHSKIN BARE+ in a cool, dry place. Make sure that the treatment window and skin tone sensor on the handset are protected
from damage.
4.
Regularly check the device (including cords) for visible signs of damage. In case of damage or cracks, stop using the device - and visit the
website for support details.
5.4 TROUBLESHOOTING
NRTL Certification marking
FCC EMC compliance
for North America
Australia Regulatory
Compliance Mark
EAC Conformity Marking
for Custom Union
Trefoil compliance mark
for Ukraine
China RoHS environmental
protection use period
Warning Optical Radiation
from device may cause
eye injury
Type BF Applied Part
Class II Equipment
Follow Instructions for use
WEEE waste disposal mark of
the European Union
European Conformity
Marking
Keep Dry
