SPC
7A | 14A | 28A
Manual
Installation:
After receiving the complete
SPC
package, please check for damage caused by transport and check the
contents of the package. Never install the
SPC
near wet conditions and make sure the power is switched
off. Only authorized personnel are allowed to install the
SPC
and to take care of technical malfunctions.
Usage:
Main switch on “AUTO”:
The
SPC
is now fully automatic. Depending on your configuration, the fans
are controlled automatically. When the
SPC
is turn on, the fans will always
run at full speed for a few seconds,
Main switch on “0”:
The
SPC
is turned ‘OFF’.
Main switch on “100%”:
In case of automatic malfunction, use this option in order to run the fans at full speed.
Set-up:
Knob 1 will set the minimal ventilation level (f.e. 20%)
Knob 2 will set the maximum ventilation level (f.e. 80%)
Knob 3 will set the ventilation bandwidth. Irrespective to the min. and max. settings, getting below
10% bandwidth is not possible (f.e. 2ᵒC)
Knob 4 will set the desired temperature. When the air temperature exceeds your desired
Temperature, the fans will automatically adjust their speed.
- Accurate climate control
- Adjustable minimum and maximum engine RPM
- 6 feet cable with temperature sensor included
- Easy installation an usage
- IP44 protection approved (damp-proof)
Attention:
The
SPC’s
are being programmed for most used fans. However, switching the minimal speed down is possible.
For this purpose turn the cal. Min potentiometer (under the socket template on the left hand side). Turn left for
minus and right for plus. Turn down the speed in such a manner that the fan will always keep running.
TURNING DOWN ANY MORE WILL INCREASE THE POSSIBILITY OF HUMMING FANS.
If the
SPC
is being
switched off through the switch (0-position) and then is restarted, first put the switch on 100% and only
afterwards on auto. This is being recommended in order to protect the connected fans.
Technical Specifications
SPC 7 Amp
SPC 14 Amp
SPC 28 Amp
Adjustable capacity
Max. 8 Amp
Max. 16 Amp
Max. 2x 16 Amp
Input
220V – 240V
220V – 240V
220V – 240V
Frequency
50/60
Hz
50/60
Hz
50/60
Hz
Dynamic range
0.5 - 8.0 Amp
0.5 – 16.0 Ampe
2 x 0.5 -16.0 Amp
Temperature sensor
4K7 at 25ᵒC
4K7 at 25ᵒC
4K7 at 25ᵒC
Bandwidth range
1 ~ 7 ᵒC
1 ~ 7 ᵒC
1 ~ 7 ᵒC
1
Fan Air
In / Out
Temperature
Sensor 500cm
Fan Air
In / Out
2 3
Switch
Schakelaar
Schalter
Fuse
Zekering
Sicherung
4
