8
CHANGING THE INTERIOR LIGHT BULB
When changing the interior light bulb (fig. 6), do the
actions below in the order they are listed:
1.
Unplug the appliance from the mains by
pulling the plug out of the electricity
supply socket.
2.
Push the interior light bulb lid
4
retainer
5
with a
flat screwdriver and with your other hand pull it
toward yourself.
3.
When you have changed the light bulb, replace
the lid and push — the lid will snap into position.
4.
Plug the appliance into the electricity supply
socket.
OPERATION PROBLEMS AND
THEIR SOLUTIONS (TROUBLESHOOTING). What if…
•
The appliance is plugged in to the mains but it does not work and.
Check that
your house electricity supply installations are in order. Check that the plug is correctly
inserted into the electricity supply socket.
•
The noise has become louder.
Check that the appliance is standing stable on a level
place. To make it level, regulate the front feet. Check if the appliance is not touching
any furniture and that no part of the refrigeration system at the back part of the
appliance body is touching the wall. Pull the appliance away from any furniture or walls.
Check that the cause of increased noise isn’t due to bottles, cans or dishes in the
appliance that might be touching each other.
•
Water has appeared at the bottom of the refrigerator compartment.
Check
whether a thaw water channel space isn’t blocked. Clean the thaw water channel space
with a cleaner intended for that purpose.
•
Water has appeared on the tempered glass shelves.
Food items or dishes in the
refrigerator compartment are touching the back wall of the compartment. Do not let
food items or dishes touch the back wall.
•
Moisture dripping from under the glass shelves.
If you placed many containers
with liquids on the shelf, moisture can condense and drip onto the shelf below. Move
some containers with liquids onto other shelves.
•
Water has appeared under the appliance.
The thaw water collection tray has
slipped off the compressor. Place the tray on top of the compressor.
•
When the appliance door is opened, the rubber sealing gasket pulls out.
The
gasket is smeared with sticky foodstuffs (fat, syrup). Clean the sealing gasket and the
groove for it with warm water containing soap or dishwashing detergent and wipe dry.
Put the rubber sealing gasket back into the place.
•
High temperature in appliance, the compressor operation pauses are short.
Ascertain whether the appliance doors are shutting tightly, whether the door wasn’t kept
open longer than necessary when taking out or putting in foodstuffs or whether a large
amount of warm food was placed in the appliance.
•
The top of the appliance has condensation on it.
The ambient relative air humidity
is above 70 %. Ventilate the room where the appliance stands and if possible remove
the cause of the humidity.
