9
you are thawing the freezer compartment if you cover them with a thick cloth and keep
them in a cool place.
•
Pull out the melt water gutter, turn it 180
O
and hook it up. After melting, place the dish
with a water gutter (see fig. 4)
•
Leave the appliance compartment door open. After the frost has thawed, dry the
surfaces and accessories dry.
•
Remove the melt water gutter, turn it 180º again and replace it. Close the appliance
door. Turn on the appliance.
REGULARLY CLEAN THE APPLIANCE.
Remember that before defrosting the appliance and cleaning the back
part of the appliance body you must disconnect the appliance from the
electrical energy supply socket by pulling the plug out of the electricity
outlet.
•
Protect the appliance inner surfaces and plastic parts from fats, acids and sauces. In
case of accidental spills – immediately clean with warm soapy water or dishwashing
detergent. Wipe dry.
•
Regularly clean the hermetic gaskets of the doors. Wipe dry.
•
Regularly clean the thaw water channel space in the refrigerator
with a special cleaner for that purpose (see fig.).
•
At least once a year clean dust away from the back part of the
appliance body and the compressor. A soft brush, electrostatic cloth
or vacuum cleaner may be used for cleaning.
•
DO NOT use detergents containing abrasive particles, acid, alcohol or
benzene for cleaning the appliance inner and outer surfaces. DO NOT
use for cleaning cloths or sponges that have coarse surfaces intended
for scrubbing.
•
If the appliance is to be left switched off for an extended period, leave its doors open.
CHANGING THE OPENING DIRECTION OF THE DOORS
It is recommended that changing the opening direction of the doors should be done with a
helper. You will need two spanners No. 8 and No. 10 and a head screwdriver.
When changing the opening direction of the doors, YOU CAN NOT lay the
refrigerator horizontally!
Warning: Always disconnect the unit from the mains before any maintenance or repair
work is carried out.
Before you start, please note the following:
∙ Always ensure that the correct number of washers is used on all hinge bolts and screws.
∙ So that the doors can close tightly against the frame, take the utmost care that they are
properly aligned during reassembly.
1.
Remove the four covers C from the housing and inside of the door.
2.
Unscrew the hinge bolt on the inside of the door in thearea C/6. Caution: Support
the door.
3.
Take off the refrigerator door.
4.
Take out the fi xing screws and remove the upper bracket 6. Note the small plastic
plate underneath the bracket.
