5
If the appliance is tilted slightly backward – the doors will close by themselves.
•
If the appliance is placed in a corner, a gap must be left between the appliance body and
the wall so that the freezer compartment door can be opened enough to pull out the
frozen product drawer. External dimensions for installation:
With integrated handles With external handles
Preparing for operation:
It is recommended to prepare the appliance for operation with a helper.
•
The apppliance must only be transported in its vertical position; do not tilt any more than
30°.
•
Remove package. Lift the appliance away from
foamed polystyrene base. Tear off adhesive
tapes. Remove all red-coloured parts from the
shelves (fig. 2.).
NOTE. When you open the freezer compartment
door a little red packing detail will fall out – it is
for transportation purposes only.
•
When positioning the appliance in chosen location, it will move more easily into position
if you lift the front a little and incline it backward, allowing it to roll on its casters. When
placing, moving, lifting the appliance, do not hold the door handles, do not
pull the condenser at the rear part of the refrigerator and do not touch the
compressor unit.
•
Take two supports 1 from the bag and insert them
into the guides 2 at the top back part of the
appliance (see fig).
•
The appliance should not be connected
to the mains until all packing and transport
materials aren’t removed. Suitably dispose the packaging material.
First use:
•
Before using the appliance for the first time, the interior and all internal accessories
should be washed with lukewarm water and some neutral soap to remove the typical
smell of a brandnew product, then dried thoroughly.
