4
POWER
INTENSITY I/II/III
MODES I/II/III
HEAT I/II
Setup and Opera�on
1. Connected the adapter cable to the cable on the foot massager.
2. Plug the home adapter into an electric outlet.
3. Turn on the device by opera�ng remote controller(refer to controller instruc�ons.).
4. When finished unplug the adapter from the outlet.
•
The device will automa�cally switch off a�er 30 minutes �mer run out.
•
Do not setup or use the device in a bathroom or similary wet/damp areas.
•
Ensure the device is not exposed to direct sunlight or placed near sources of heat.
Note:
This product produces a warming heat. It is not intended to be used as a therapeu�c
hea�ng pad. Please allow a few minutes to reach maximum temperature.
The maximum temperature: approx 130F.
Controller instruc�ons
Power:
Press to turn the
device on or off.
Vibration massage:
Press to change the Mode
between mode I to III.
The vibra�on massage
can be turned on
independently.
Heat:
Press to ac�vate the
heat func�on, you may
cycle through High, Low
and off se�ngs.
The heat can be turned
on independently.
Intensity:
Press to choose Low/
Medium/High intensity
of vibra�on
