250
iii-1
M4x8 (4x)
iii-2
iii-3
2
1
5
4
3
Installation
iii Installation procedures
Wheel balancer:
Refer to the drawing for correct wheel balancer
positioning. If the wheel balancer needs securing,
we recommend fi xing elements with a diameter of
8 mm, quality 8.8 or higher.
Supports for Accessories:
•
Unpack the 4 threaded accessory support studs
and the support plates.
•
Refer to
Figure iii-1
. Fit the 4 threaded accessory
support studs and the plates.
Clamping devices:
•
Put the clamping devices on the accessory studs.
Fitting and connecting the monitor
Fig. iii-2 VESA support
The 4 screws needed (M4x8) to fi x the VESA support
to the monitor are part of the kit supplied.
Fix the VESA support to the monitor.
Figure iii-3 Connection of monitor and PC
Caution
Before connecting the electronic cables turn off the
mains switch.
Plug in the plug (
1, Fig.iii-3
) of the power supply
cable.
Insert the monitor connector into the right socket
(
2
) of the embedded unit.
Insert the connector USB (
3
) into the PC and the
monitor.
Insert the monitor main connector
(
4
) in the
monitor socket.
Insert the audio Jack (
5
) in the monitor socket.
Note:
The warning beeps from the machine
cannot be heard if the audio cable is not
connected.
iv Test procedures
•
Balance a wheel to less than 0.25 oz. (5 grams) per
plane.
•
Perform a User Calibration.
F
8.2.
v Instructing the operator
(Following applies only if a unit is installed by a service
Technician)
•
Show and explain the Safety Booklet.
•
Show the operator how to switch the unit on and off.
•
Show the operator how to perform an emergency stop.
•
Show the operator how to select a wheel type, enter
data and apply a weight.
..
_
..........
