entering a power tool will increase the risk of electric shock.
•
Do not abuse the cord. Never use the cord to carry the tools or
pull the plug from an outlet. Keep cord away from heat, oil,
sharp edges or moving parts. Replace damaged cords
immediately.
Damaged cords increase the risk of electric shock.
•
When operating a power tool outside, use an outdoor
extension cord marked “W-A” or “W.”
These cords are rated for
outdoor use and reduce the risk of electric shock. When using an
extension cord, be sure to use one heavy enough to carry the
current your product will draw. An undersized cord will cause a drop
in line voltage resulting in loss of power and overheating. The
following table shows the correct size to use depending on cord
length and nameplate ampere rating. If in doubt, use the next
heavier gage. The smaller the gage number, the heavier the cord.
Minimum Gage for Cord Sets
Volts
Total Length of Cord in Feet
120V
0-25
26-50
51-100
101-150
240V
0-50
51-100
101-200 201-300
Ampere Rating
More Not
more
AWG
Than
Than
0
-
6
18
16
16
14
6
-
10
18
16
14
12
10
-
12
16
16
14
12
12
-
16
14
12
Not Recommended
PERSONAL SAFETY
•
Stay alert, watch what you are doing and use common sense
when operating a power tool. Do not use tool while tired or
under the influence of drugs, alcohol, or medication.
A moment
of inattention while operating power tools may result in serious
personal injury,
•
Dress properly. Do not wear loose clothing or jewelry. Contain
long hair. Keep your hair, clothing, and gloves away from
moving parts.
Loose clothing, jewelry, or long hair can be caught
in moving parts.
•
Avoid accidental starting. Be sure switch is off before
plugging in.
Carrying tools with your finger on the switch or
English
General Safety Rules
WARNING! Read and understand all instructions.
Failure to
follow all instructions listed below may result in electric shock, fire
and/or serious personal injury.
SAVE THESE INSTRUCTIONS
WORK AREA
•
Keep your work area clean and well lit.
Cluttered benches and
dark areas invite accidents.
•
Do not operate power tools in explosive atmospheres, such as
in the presence of flammable liquids, gases, or dust.
Power
tools create sparks which may ignite the dust or fumes.
•
Keep bystanders, children, and visitors away while operating a
power tool.
Distractions can cause you to lose control.
ELECTRICAL SAFETY
•
Grounded tools must be plugged into an outlet properly
installed and grounded in accordance with all codes and
ordinances. Never remove the grounding prong or modify the
plug in any way. Do not use any adaptor plugs. Check with a
qualified electrician if you are in doubt as to whether the outlet
is properly grounded.
If the tools should electrically malfunction or
break down, grounding provides a low resistance path to carry
electricity away from the user.
•
Double insulated tools are equipped with a polarized plug (one
blade is wider than the other.) This plug will fit in a polarized
outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified
electrician to install a polarized outlet. Do not change the plug
in any way
. Double insulation
eliminates the need for the three
wire grounded power cord and grounded power supply system.
•
Avoid body contact with grounded surfaces such as pipes,
radiators, ranges and refrigerators.
There is an increased risk of
electric shock if your body is grounded.
•
Don’t expose power tools to rain or wet conditions.
Water
