8
5. From the back of the system gently push up on the camera (indicated by red arrows) arms to the mobility
positions.
6. Once the camera arm(s) have been properly folded the holding pins will automatically lock the cameras in the
mobility position.
7. Once both Camera arms have been locked in the Mobility Mode, unlock both front wheels on the mobility cart
and relocate the system to a different bay.
8. Please follow the installation instructions to properly square the system in the new bay.
9. Follow the “Power Up” sequence mentioned earlier in this quick start.
10. To lower the camera arms remove the pressure from the arms by pushing the cameras in the direction of the
arrows and pulling the holding pins. Carefully lower the cameras down. Once lowered to the alignment posi-
tion, the locking pins will not lock. This will allow the camera arms freedom should there be an obstruction
below them during the alignment process. There will be no need to manually raise the carriage system as the
system will automatically self-track once the alignment process is started.
Holding Pin
Holding Pin
Holding Pins
Summary of Contents for 770XD
Page 4: ......
Page 13: ...Blank Page ...