EN - 15
Fig.17
4.2 MOUNTING TUBELESS TIRES
A.
Clean entire rim surface (Fig.18).
Fig.18
Liberally lubricate both beads of the tire with approved
tire lubricant (Fig.19).
Fig.19
F.
Insert the mount/demount tool under the bead and
over the support of the mount/demount head. Lift
the bead onto the mount/demount head. To make
this operation easier, insure that the bead of the tire,
directly across from the mount/demount head, is in the
drop center of the wheel. Push the tire into the drop
center with your hand or optional bead depressor tool
if necessary.
If desired, the mount/demount tool can be removed
after lifting the bead onto the mount/demount head
(Fig.15), or you may remove the tool after the bead
has been removed.
Fig.15
G.
Rotate the turntable clockwise (pedal down) and,
at the same time, push down on the tire sidewall to
move the bead into the drop center of the rim (Fig.16).
Fig.16
H.
Repeat the process for removing the lower bead.
This time, lift the bead opposite to the mount/demount
head to keep it in the drop center (Fig.17).
Move the swing arm aside and remove the tire.
