9
200/300 Series
— VTC eLock Instructions
200/300 Series
VTC eLock — Manual Programming
continued
4.
LCD Contrast
will be displayed.
5. Enter 1 - 9 on numeric keypad or
+/-
buttons to adjust.
6. Press “NEXT/SELECT” when done.
7. Press “BACK/CANCEL” to return to main menu.
LCD Backlight
Using
LCD BACKLIGHT
the brightness of the display can be
adjusted.
1. Press “MENU.”
LOGIN PLEASE
will be displayed.
2. Scan valid credential or enter 4-14 digit PIN and press
“ENTER.”
3. Press “DOWN” button to highlight
LCD BACKLIGHT
and press
“NEXT/SELECT.”
4.
LCD Backlight
will be displayed.
5. Enter 0 - 9 on numeric keypad or
+/-
buttons to adjust.
(“0” = OFF)
6. Press “NEXT/SELECT” when done.
Set Beep Volume
Using
SET BEEP VOLUME
, the audible beep can be
adjusted.
1. Press “MENU.”
LOGIN PLEASE
will be displayed.
2. Scan valid credential or enter 4-14 digit PIN and press
“ENTER.”
3. Press “DOWN” button to highlight
SET BEEP VOLUME
and
press “NEXT/SELECT.”
4.
Beep Volume
will be displayed.
5. Enter 0 - 9 on numeric keypad or
+/-
buttons to adjust.
(“0” = MUTE)
6. Press “NEXT/SELECT” when done.
7. Press “BACK/CANCEL” to return to main menu.
Reset Net Schedule
A PROPERLY CONFIGURED AND ENABLED NETWORK eLock
IS REQUIRED TO MAKE USE OF THIS FEATURE.
Only
Supervisors
are allowed to
RESET NET SCHED
.
Using
RESET NET SCHED
. the scheduled network check-in
time can be set.
1. Press “MENU.”
LOGIN PLEASE
will be displayed.
2. Scan valid credential or enter 4-14 digit PIN and Press
“ENTER.”
3. Press “DOWN” button to highlight
RESET NET SCHED
. and
press “NEXT/SELECT.”
4.
NETWORK TIMING RESET
will be displayed. The eLock will
follow the programmed or default check-in frequency from
this time of day forward.
For example:
Programmed Update Interval as set in LockView is 12 hours
(twice/day). The time of day was 10 a.m. when the eLock
was initialized.
Therefore, the eLock update time is 10 a.m. and 10 p.m. The
desired update time is 6 a.m. and 6 p.m.
Using the
RESET NET SCHED
. feature, the above steps should
be followed at 6 a.m. or 6 p.m.
Name of last credential on LCD
The name, time, day and date of the last credential to
successfully access the eLock appears at the bottom of the
reader display.
