30
5.3.1-1
5.3.1-2
Operation
5.3.1
Rim data input
Dimensions can be measured by hand and then typed
in on the keyboard.
Dimension
Units
diameter:
inches (default) or mm.
rim width:
inches (default) or mm.
offset:
millimetres.
To change the units, refer to Chapter 5.2.4.2.
MANUAL data entry
Manual data entry is required only if the gauge arm
malfunctions. In that case proceed as follows:
- Rim or tyre diameter
•
Read the nominal rim diameter directly on the rim
or tyre itself.
•
Select the diameter key on the control panel. The
last value entered appears.
•
Enter the value read previously using the appropriate
keys (refer to Chapter 4.2).
•
Select another measurement to edit (if necessary)
or spin the wheel.
- Rim width
•
Measure the rim manually with the callipers (refer
to Fig. 5.3.1-1) or read the measurement directly
on the rim itself if it’s written there.
•
Press the “Rim width” key.
•
Enter the value manually using the keyboard.
- Offset:
•
Position the gauge arm correctly as described
above in the “Rim Diameter” phase of the Automatic
Data Entry operation
•
Read the arm extraction value on the gauged
column.
•
Enter the value read previously using the appropriate
keys.
Summary of Contents for Sun SWB 100
Page 90: ...90 Blank Page ...