58
5-21
5-22
5-23
Operation
5.8.1 Alu 2P and Alu 3P (HWM) weight
modes:
Refer to
Figure 5.21
.
The gauge arm must be used to apply the stick-on
weight(s).
—
Index the wheel to the exact position for correction
in the right correction plane.
When the position is reached, two green arrows
appear.
—
Press the pedal of the main shaft lock to hold the
wheel in this position.
Decide to use Hidden Weight Mode «
HWM
» now (
F
5.9).
—
Clean the fi tting position before attaching the
adhesive weights.
—
Insert at the centre of the gauge arm an
adhesive weight that complies with the imbalance
measured and remove the protective tape from
the adhesive strip
(Figure 5-23)
.
Note
: When the value “
0
“ appears while moving the
arm, the machine beeps to indicate that the
correct application position has been reached.
•
Apply the weight to the correct point on the rim.
•
Rotate the wheel to the next WAP position, put the
stick-on weight on the gauge arm and apply the
weight at the left plane reference point (
Fig. 5-21
).
—
After applying the balance weights perform a Test Run.
