99
Scope and Multimeter Operations
Operations
8.5 Operations
This section describes configuring the scope or meter and performing tests.
8.5.1 Starting the Scope and Multimeter
Use the following procedure to set up the scope multimeter for performing tests.
z
To start the scope multimeter:
1.
Select the
Scope Multimeter
icon on the Home screen.
The Scope Multimeter main menu, a list of setup options, displays;
–
Lab Scope
–
Ignition Scope
–
Graphing Meter
–
Digital Multimeter
–
Presets
2.
Select from the menu options.
A submenu of scope or meter configuration displays, see below for additional information.
3.
Select a configuration and the Scope Multimeter opens.
Presets
Presets are factory configured meter settings for common component tests. Selecting opens a list
of available setups. Selecting from the list opens the scope multimeter configured to perform the
selected test. In addition to the factory presets, you can create your own custom meter
configurations and save them as presets.
Lab Scope Options
The following options are available for testing:
•
4 Channel Lab Scope
•
Volts DC
•
Low Amps (20)
•
Low Amps (40)
•
Low Amps (60)
•
Ignition Probe
•
100 PSI Vacuum
•
100 PSI Pressure
•
500 PSI Pressure
•
5000 PSI Pressure
