Motorhome Detailed Installation Instructions
EQ COMPACT INSTALLATION INSTRUCTIONS
RV SNAPPAD 02
• SnapPad installation is best performed on a hard, level or near level surface – preferably a hard surface (concrete or asphalt). Wheel chocks can be placed in front of and
behind the RV wheels for additional safety.
• Be sure to thoroughly clean and dry your landing feet prior installing your SnapPads.
• Spread a small bead of concentrated dish soap around the lip of the SnapPad and metal landing foot to aid installation.
Do NOT use any petroleum based lubricant,
such as WD-40®, as it may negatively react with the binder in your SnapPads.
• Install one SnapPad at a time and use the manual jack operation if possible. Refer to your owners manual for instructions.
• Most jacks are 18” - 24” under your RV. You might need to use a tool such as a broomstick to align your SnapPads, if necessary.
• Install one at a time. It’s important that you align your SnapPads correctly to ensure they install properly and are not damaged during the
installation process.
ALL 4 SIDES MUST BE ALIGNED WITH THE LIP OF THE PAD.
Do NOT install any of the corners to align with the slots
on the lip. These slots are for drainage and help with removal should you ever need to take your SnapPads off.
INSTALLATION TIME: 3 - 6 MINUTES PER PAD.
• Once aligned, begin lowering your jack. Keep an eye on the landing foot as it extends. Stop extending when the foot is about 2 to 3 inches from the SnapPad. Double check
to make sure it is centered and the 4 sides line up with the SnapPad, re-align if necessary and then continue extending the landing gear to complete installation.
KEEP YOUR FINGERS AND ANY FOREIGN OBJECTS CLEAR WHEN LOWERING THE JACK INTO PLACE.
• You should hear a distinctive “snap” as the lip engages. Visually confirm the lip is fully engaged around the perimeter of the landing foot.
• If your lip hasn’t fully engaged, raise your jack and place a shim (small piece of wood no thicker than 1/4”) under the side that hasn’t engaged. Lower your jack again until
that side snaps into place.
• Wipe off any excess soap and repeat the installation process, in sequence, on your remaining jacks.
