35
Specifications
ENGINE:
20 HP* Briggs & Stratton
Make
Briggs & Stratton
Model
Intek
Horsepower
20 @ 3600 rpm
Displacement
30.5 Cu. in (582cc)
Electrical System
12 Volt, 9 amp. Alternator, Battery: 230 CCA
Oil Capacity
64 Oz. (1.9 L)
18.5 HP* Briggs & Stratton
Make
Briggs & Stratton
Model
Intek
Horsepower
18.5 @ 3600 rpm
Displacement
38 Cu. in (502 cc)
Electrical System
12 Volt, 9 amp. Alternator, Battery: 230 CCA
Oil Capacity
48 Oz. (1.4 L)
CHASSIS:
LT Series
Fuel Tank Cap.
Capacity: 3.5 Gallons (13,2 L)
Rear Wheels
Tire Size: 22 x 10 -8
Inflation Pressure: 10 psi (,68 bar)
Rear Wheels
Tire Size: 20 x 8.0 -8
Inflation Pressure: 10 psi (,68 bar)
Front Wheels
Tire Size: 15 x 6.0-6
Inflation Press.: 12-14 psi (,82-0,96 bar)
TRANSMISSIONS:
K46
Type
Hydrostatic Tuff Torq K46
Hydraulic Fluid
10w 30 Premium Engine Oil
Speeds
Forward: 0-5.5 MPH (9.0 km/h)
@ 3400 rpm
Reverse: 0-3.0 MPH (4.6 km/h)
Continuous Torque
170 ft. lbs.
Output
Drawbar Rating
227 lbs (103 kg)
Maximum Weight
675 lbs (306 kg)
on Axle
DIMENSIONS:
LT Series
Overall Length
72”
Overall Width
37”
Height
45”
Weight
18.5hp Tractor
w/ 38” Mower Deck
480 lbs. (218 kg)
20hp Tractor
w/ 44” Mower Deck
532 lbs. (241 kg)
NOTE: Specifications are correct at time of printing and are subject to change without notice.
* The power ratings for an individual engine model are initially developed by starting with SAE (Society of Automotive
Engineers) code J1940 (Small Engine Power & Torque Rating Procedure) (Revision 2002–05). Given both the wide
array of products on which our engines are placed, and the variety of environmental issues applicable to operating
the equipment, it may be that the engine you have purchased will not develop the rated horsepower when used in a
piece of power equipment (actual “on–site” power). This difference is due to a variety of factors including, but not
limited to, the following: differences in altitude, temperature, barometric pressure, humidity, fuel, engine lubrication,
maximum governed engine speed, individual engine to engine variability, design of the particular piece of power
equipment, the manner in which the engine is operated, engine run–in to reduce friction and clean out of combustion
chambers, adjustments to the valves and carburetor, and other factors. The power ratings may also be adjusted
based on comparisons to other similar engines utilized in similar applications, and will therefore not necessarily match
the values derived using the foregoing codes.
