Snapper 7600069 - 7600070, Safety Instructions & Operator'S Manual

Instruction Manual No. 7102356  (Rev. C, 06/04/2008) 

TP 200-5352-C-AT-N 

4

Install Grass Bags 
1) 

Align the slot on the hanger of the 

Grass Bag Assembly (7500995) with 
the tab on the grass bag support.  

2) 

Insert the tab into the slot. Repeat 

for all three grass bags. See Figure 4. 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
Install Cover Assembly 
1) 

Attach the Cover Assembly (7500996) 

to the Grass Bag Support. Insert one Hinge 
Pin (M720525) into each hinge, and secure 
with one Hair Pin (1960074). See Figure 5. 

2) 

Lower the cover, and pull the latch 

down over the grass bag frame. The 
cover must be fully closed and latched. 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Install Grass Bag Adapter 
1) 

46” & 52” Models Only – Attach the 

Latch Pin (M720543) to the appropriate 
Grass Bag Adapter, using one carriage 
bolt 1/4-20x5/8 (1960252) and one 
center lock flange nut 1/4-20 (1930642). 
See Figure 6 (inset). 

2) 

The Grass Bag Adapter attaches to 

the deck using two bolts and two wing 
nuts, provided with the kit. See Figure 
6. Note – some model tractors will 
already have the bolts installed in the 
deck. You can use them to attach the 
grass bag adapter.   
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

3) 

Lift the discharge deflector. Align the 

two holes in the grass bag adapter with 
the holes in the deck. Note - do not 
remove the discharge deflector. 

4) 

Insert two carriage bolts 5/16-18x1-

1/4 (1960223) from inside of deck. Note 
- insert forward carriage bolt first. 

Secure with two wing nuts 5/16-18 
(M720125).  Tighten wing nuts securely. 

Figure 6 

Figure 4 

Figure 5 

Grass Bag 
Adapter 
42” – 7501003 
46” – M720560 
52” – 7102377