5
ASSEMBLING YOUR SUPER TITAN XXL
1. Unpack and lay out all parts.
2. Thread DOOR HANDLE SPOKES
onto the hub on DOOR (Part 12).
3. Install a fresh high-quality 9V battery in the Entry Keypad (See page 10).
4. Important – Remove temporary door hinge screws from door hinges.
5. Enter the factory combination code and open the DOOR, then lift it off the
DOOR FRAME (Part #6) and set aside.
6. Assemble Top, Bottom and Sides (Parts 1 through 4) first. Then bolt the
entire assembly onto the BACK (Part 5).
7. For additional help watch our “Live Action Assembly Video” on the
“Features” page at www.snapsafe.com.
Notes:
1. Each part is marked with an assembly number, orientation and
instructions.
2. Each part’s orientation e.g. TOP, BOTTOM, FRONT, etc. matches its
orientation in the assembled vault. LEFT and RIGHT are as you face the
front of the vault.
3. For easier assembly, remove the FIRESHIELD blankets from the TOP,
BOTTOM and SIDEWALLS. Stuff them back into place before interior
assembly.
4. Screw on nuts loosely at first. Once all Exterior Panels are aligned and
seated, tighten the nuts. The Fireshield blankets must tuck under edges to
allow interior panels to fit.
5. The INTERIOR SIDE PANELS are designed to fit snuggly. Insert them
through the door opening and then slide into final position by placing
front edge into place and then pressing the back edge against ouside
walls.
6. Insert the INTERIOR BOTTOM PANEL through the door opening between
the front and back shelf strips and then drop into position front-to-back.
