4 Master Section
4.6 Setup
In setup mode a permanent offset can be set for each clock channel, i.e. to compensate for technical
latencies. Also, the second outputs of clock channels 1/2 can be switched between DIN-sync and
Midi. And there are some options for the analog outputs of clock channels 3/4 to be selected.
Activate Setup Mode:
To enter setup mode press Manual, and while holding it down press Clock.
While in setup mode the Manual and Clock LEDs flash simultaneously.
Exit Setup-Modus without Storing:
To exit setup mode, again press Manual and while holding
it down press Clock. This will leave the setup mode without permanently storing changes. Changes
you may have made will be lost at the next power-down of the ACME-4.
Store and Exit Setup Mode.
To permanently store changes of the setup parameters press Man-
ual, and while holding it down press Recall.
Note!
After leaving the setup mode the ACME-4 is always in manual mode. Make sure the all
the Shift fine controls are returned to their center positions, unless you wish to shift a channel in
addition to its permanent offset.
11
