12
OPERATING INSTRUCTIONS
1. Power the Display On/Off and Select Desired Mode
Or
Turn the heater on by pressing the ON/OFF button on the
control panel or by pressing the Power button on the
supplied remote control.
Turn the heater off by pressing the ON/OFF button on the
control panel or by pressing the Power button on the
supplied remote control.
Note: Powering off the heater will stop the heating process
only. The fan will continue to blow for approximately 1
more minute to allow for the interior components to cool.
The fan will then turn off automatically.
Or
Select a heat Mode.
Press the MODE button to toggle between the three heat
modes.
High Mode uses 1500W; Low Mode uses 800W. ECO
mode is an Economic Energy Saving Function. When ECO
mode is chosen, the heater will set the temperature
automatically to 68
°
F
（
20
℃）
under this mode
2. Setting Desired Temperature
Or
Or
Adjust the desired temperature by pressing the Up/Down
arrows on the control panel or remote control.
Or
Desired temperature options vary from 59
℉
to 86
℉
, or
from 15
℃
to 30
℃
. Once you have chosen the desired
temperature, the heater will remain on until the room
temperature increases to the temperature on the digital
display. The heater will cycle on and off to maintain that
desired room temperature.
Press
℃
/
℉
button to change the display temperature
between Fahrenheit and Celsius.
The Fahrenheit indicator LED will light, when the
temperature is displayed in Fahrenheit.
The Celsius LED will light, when the temperature is
displayed in Celsius.
