IQH1S IU Enclosure
SECTION 4
IQH1SOPS
23/11/06
www.snellwilcox.com
Version 1 Issue 4
4.11
Default Unit
On power-up the default unit will be automatically
connected, its menus retrieved and will be ready
for active control.
Save
Default Unit :06
Name
(0000) 00 00
Clear
Default Unit
To define the default unit select Default Unit. Press
the button adjacent to the default text arrowhead
until the desired number is reached. (This number
is the number assigned to a particular unit in the
Auto Connect set-up) The name of this unit will
appear in the second line of text.
Select Save to save this setting.
The Clear selection sets the default unit to `None'
Note that if no units have been assigned numbers
in the Auto Connect set-up a ? will appear in the
second line of text. Also when the numbers are
selected (in rotation) the word `None' will appear
after Default Unit when the number 15 is
exceeded. This confirms that no units have been
assigned a number.
Note that only one unit may be designated as the
default unit.
BackLight
Backlight Mode
AUTO
Save
Backlight
Selecting this function allows the backlighting of the
display windows to set, by rotating the spinwheel,
to the following modes:
OFF
Backlight always Off. Use this mode where
ambient light level is high.
ON
Backlight always On. Use this mode where
ambient light level is low to improve text visibility.
AUTO
Backlight will normally be On but will default to Off
after 2 minutes. The backlight will return to Auto On
whenever any front panel control is operated.
Press the button adjacent to the Save text to save
the backlight mode.