IQH1S IU Enclosure
SECTION 4
IQH1SOPS
23/11/06
www.snellwilcox.com
Version 1 Issue 4
4.14
Front Panel Setup via the RollCall Control Templates
Control
Name
The control panel may be given a name using this
function (e.g. Edit Suite, Studio 2 etc.) The
maximum number of characters, including spaces,
is 19 and may consist of letters and numbers
(ASCII Characters)
This function allows the name of the front panel as
seen on the network, to be changed.
To change the name, type the new name in the
text area and then select
(return); the new
name will now be saved.
Selecting Preset
will return the text to the
default name.
Address
The address of this control panel will be displayed
as a 2-digit hexadecimal code.
Note that the code 0,0 effectively switches the unit
off from the network. The codes 0,1 to 0,F inclusive
are reserved for bridge addresses. Codes 1,0 to F,
F inclusive are available to the user.
The address code is user defined in the range 1,0
to F,F. Use the scrollbar to select the desired code.
Minimum/Maximum Address Range
The front panel can only hold a maximum of 200
addresses. The Min and Max Unit Addr (Address)
function allows a range of addresses to be
configured for partial use of the network.
The Minimum Address Range selection sets the
minimum address.
The Maximum Address Range selection sets the
maximum address.
The overall range of addresses is from 1 to 255.
Backlight
This function allows the backlighting of the display
windows to set to the following modes:
Off
Backlight always Off. Use this mode where
ambient light level is high.
On
Backlight always On. Use this mode where
ambient light level is low to improve text visibility.
Auto
Backlight will normally be On but will default to Off
after 2 minutes. The backlight will return to Auto On
whenever any front panel control is operated.
Net Show
This function allows the front panel to be "hidden"
from the network system.
When unchecked this front panel will not appear in
the Module List displayed on other control panels in
the system.
