CPP100
SECTION 2
CPP1OPS
25/10/06
www.snellwilcox.com
Version 1 Issue 6
2.1
Installation
PREFIX is supplied in a dedicated carton provided by
the manufacturer and should not be accepted if
delivered in inferior or unauthorised material.
Carefully unpack the unit and check for any shipping
damage or shortages. If you encounter any problems
please report them to the supplier immediately.
IMPORTANT NOTE:
In case of complaint the carrier
should retain the packing material for inspection.
The unit is designed for mounting in a 1RU slot in a
19" racking system.
The chassis is equipped with a pair of mounting ears
attached to the side plates. Suitable screws should
be inserted through the holes in these flanges to
secure the chassis to the racking system. Ensure that
the rack is correctly configured to accept the 1U unit
with chassis runners positioned to support the unit.
Under no circumstances should the unit be hung from
its rack ears alone as this will result in irreparable
damage to the case.
Whilst mounting the unit please try to ensure that
there is adequate airflow to the rear of the unit.
If a PREFIX is to be mounted in a rack together with
convection
cooled
equipment,
e.g.
Analogue
distribution amplifiers ensure that it is not located
above or interspersed with these units. The
equipment should be operated in an environment
having a temperature between 0
o
C and +30
o
C and a
relative humidity of less than non-condensing.
S N E L L & W I L C O X
C P P 1 0 0
HOME
PRESET
BACK
FREEZE B YPASS
REC
TRANS
MEDIAN SPATIAL
LINEAR SCRATCH ENHANCE
SETUP
MEM
CONFIG
NET
PATTERN
MON
INPUT
GLK
FILTERS
PICTURE
PREFIX
S ELECT
Pulling the two catches forwards opens the front
panel. We have found that the easiest way of doing
this is with your thumbs! The internal hinge
mechanism has been designed so that the panel can
hinge forwards and downwards to leave unrestricted
access to the boards.
Electrical Connection
The power supply accepts AC mains in the range 90
to 250 Volts AC @ 50Hz to 60Hz and will auto switch
to these standards. The main power connection,
located at the rear of the unit, is made via a fused
IEC320 inlet socket (fuse 2.5 AT, Max Current 1.8A)
with the middle pin as earth conductor. This electrical
connection should be located as close to the unit as
possible to facilitate easy isolation.
Power Switch
The power switch and the power-ON indicator are
located behind the front panel.
