background image

6

Non-THX Low Level Connection

When connecting the ICS Sub 24 mk3 to 
electronics that does not have a THX control 
system, use the low level (also called line level) 
connections whenever possible. Even if you 
do not have a separate preamp and power 
amp, many receivers and integrated ampli-
fiers include ”Preamp Out“ and ”Amplifier In“ 
connectors. 

When using the low level connections, the 
signal from the High Pass Outputs that is 
returned to your amplifier is high pass filtered 
to remove sound below 80Hz. This is a non-
adjustable filter. It is not affected by the setting of the Crossover control. See the Fine Tuning section of this manual 
for more information. 

Subwoofer Output Connection

Some electronics have monophonic subwoofer 
outputs. If your system has this type of an output 
it can be connected to either of the low level 
inputs. The benefit of using this type of connec-
tion instead of using the THX setting is that it 
does not bypass the controls of the ICS Sub24 
mk3.. You can still use the level control to adjust 
the output of the subwoofer. Typically such out-
puts are low pass filtered, so you should set the 
ICS Sub 24 mk3 crossover control to it’s highest 
setting to minimize its effect. If listening test show there is an excess of mid-bass sound you may want to use a lower 
crossover control setting. See the “Fine-Tuning Your Subwoofer” section for more information.
 

Warning:

 To reduce the risk of electric shock, always switch off the subwoofer and the amplifier and or receiver when 

making connections to the subwoofer and speakers.

THX® Connection

Use this setup when the ICS Sub 24 mk3 is con-
nected to a receiver or surround sound controller 
that has a built-in THX control system. This input 
bypasses 

ALL

 the crossover and control circuitry 

of the ICS Sub 24 mk3. 

C O N N E C T I O N

������������

������������������

���

���

�����������������
�����������������

������������������
����������������������

������������������
����������������������

������������������

����������������������

����������������

������

���

���

��

������������������

�������������

�����������

������������������
����������������������

����������������������

����������������

���

���

Summary of Contents for ICS Sub 24 mk3













Reviews: