IQH3A IQ 3U Modular Enclosure
www.snellgroup.com
Operation
Issue 2 Rev 2
Page 53
©
2014 Snell Limited
4.6.4 Information Field(s)
Information fields that may be edited by user to specify any information desired. See
4.6.6
Examples of Slot Use on page 54.
For example, these could be used to name signal paths associated per card. 2 fields are
available allowing a maximum of 2 * 19 characters displayed.
If these fields have edited values then a corresponding log field is raised per slot.
Log field: INFORMATION1= and INFORMATION2=.
4.6.5 Power Usage
This displays the power usage of the unit fitted in the slot. See
4.6.6 Examples of Slot Use on
page 54.
When a card powers up in a slot, its rated power is automatically updated in the Power Usage
control.
If a module's ID is not recognized the power usage will indicate
??
. If this occurs please
contact Snell customer service to obtain the correct power usage value.
Some IQ Modular cards do not appear in the port listing (eg SDA31/33). In this case the
Non
Rollcall
Enable check box should be enabled, and the type added in the
IDNAME
field.
An “A” type chassis will report power usage in Watts (W). A “B” type chassis will report as
Load Units (LU).
The power usage reported may be updated if the unit logs a POWER_USAGE log field.
Note:
A global control for these logging fields applies in Logging(2).
These fields are always logged whether a unit is present or not.
Information 1
Information 2
Preset
Save
Power
Slider
