IQOTR31
www.snellgroup.com
Controlling the IQOTR31 from the RollCall Control Panel
Issue 1 Rev 1
Page 14
©
2012 Snell Limited
6.
Controlling the IQOTR31 from the RollCall Control Panel
6.1 Information Window
The information window is displayed in the upper-right corner of each screen and displays
basic information about the input status, video, audio and reference status of the module.
6.1.1 Unit Status
The first two lines of the Unit Status display the input status, detected rate, and input selection
method for Input 1.
The third and fourth lines of the Unit Status display the same information for Input 2.
6.2 Inputs
The
Inputs
screen enables the type of input signal to be selected.
6.2.1 Input 1 SDI Rate (SDI IN 1) / Input 2 SDI Rate (RX IN 2)
•
Auto:
When selected, the unit will automatically detect and reclock any valid input
signal, and the detected rate will be displayed in the Unit Status.
If anything else is detected, the output will not be reclocked. If the
On Input Loss /
Mute
option is selected, the output will be muted; or, if the
On Input Loss / Pass
option is selected, the output will be passed through.
•
SD/DVB-ASI (270 Mb):
When selected, the unit will reclock only SD/DVB-ASI (270
Mb) signals.
When selected, the
On Input Loss
controls are greyed out and are inactive. If any
other standard is applied to the unit, the output will be muted.
