IQOTR31
www.snellgroup.com
Controlling the IQOTR31 from the RollCall Control Panel
Issue 1 Rev 1
Page 15
©
2012 Snell Limited
•
HD (1.5 Gb):
When selected, the unit will reclock only HD (1.5 Gb) signals.
When selected, the
On Input Loss
controls are greyed out and are inactive. If any
other standard is applied to the unit, the output will be muted.
•
3G (3 Gb):
When selected, the unit will reclock only 3G (3 Gb) signals.
When selected, the
On Input Loss
controls are greyed out and are inactive. If any
other standard is applied to the unit, the output will be muted.
•
Reclock Bypass:
When selected, the unit will not reclock the input signal. If a
supported rate is detected, the Unit Status will display the detected rate, otherwise, ***
will be displayed.
•
If the
On Input Loss / Mute
option is selected, the output will be muted whenever a
recoginized rate is not detected; or, if the
On Input Loss / Pass
option is selected,
any signal standard, frequency, etc… will pass through.
6.2.2 Output 1 / Output 2
•
Mute:
When selected, this option applies a mute on the output.
•
On Input loss / Mute:
When selected, if the Input signal is lost, the output signal will
be muted.
•
On Input loss / Pass:
When selected, if the input signal is lost, it will be passed
unchanged.
6.2.3 Fiber Optic Tx 1
This section displays the following information about the fiber optic output signal:
•
Tx Wavelength
•
Laser Bias
•
Laser Bias State
•
Tx Power
•
Tx Power State
•
Laser OFF:
Selecting this option disables the laser.
•
Laser OFF - On Input Loss:
Selecting this option disables the laser if the input signal
is lost.
6.2.4 Fiber Optic Tx 2
This section displays the following information about the fiber optic input signal:
•
Rx Power
•
Rx Power State
Note:
These controls only apply to the SDI outputs on the BNC. The laser output is controlled by
the Laser OFF and Laser OFF - On Input Loss controls.
Note:
These controls only apply to the fiber optic output signal. The SDI outputs on the BNC are
controlled by the Mute and On Input Loss - Mute controls.
When the unit is forced to a particular standard, the laser controls are not grayed out, and
the laser will still be active if an incorrect standard is applied unless
Laser OFF - On Input
Loss
is selected.
