Low-P
ass Filter/Cr
ossover
This contr
ol sets the fr
equency of the low-pass
filter
, and is fully adjustable fr
om 50 to 125Hz.
If you choose to allow your processor to low pass
filter
the B300, use the "SUB IN" RCA connector.
To use the internal lowpass, use the "Low Level In".
Level Contr
ol/V
olume
The Bass Level contr
ol adjusts the sound level
output of the
Sub300
It is located on the
fr
ont
(or top)
of the cabinet
Phase Switch
Determines whether the subwoofer adds or
cancels in the cr
ossover r
egion. The pr
oper set-
ting changes based upon the curr
ent location
of the speaker
.
P
ower
The main power switch is located next to the
power cor
d socket. Push in the top side of the
switch to turn on the main power to the sys-
tem. Push in the bottom side to turn off the
main power
. Usually the only time the main
power switch should be turned off is when the
subwoofer will not be used for an extended
period of time, such as when you ar
e away on
a vacation.
1
2
3
4
5
6
7
8
Line-Level Inputs
The line-level inputs incorpor
ate a fixed 80Hz
high-pass filter
. When used in conjunction with
the line level outputs
, these inputs will r
edir
ect
all bass information below 80Hz fr
om your
main speaker
s to
the sub
.
Use the "High pass out" to filter the mains.
Speaker-Level Inputs
The
Sub300
utilizes high-level inputs
. The
A removeable wire block faciliate
s
easy connection of bare wire.
Bass D
river
The
Sub300
uses a 1
0-inch (250 mm) cus-
tom-built bass unit
with aluminum cone
and a die-cast
aluminum chassis.
Handmade Cabinets
Our cabinet department hand assembles each
unit, and then hand sands each sever
al times
.
The r
esult is a cabinet of exceptional workman-
ship, with sharp corner
s and smooth sides
.
