snode SNODE8731B, Owner'S Manual

TROUBLE SHOOTING

17

1. 

PROBLEM: 

The bike wobbles when in use.

          1) 

SOLUTION:

 Turn the 

Foot Pads (36) 

on the 

Rear

 and 

Front Tube (38) & (53)

 or as needed

               to level the bike.
 
2. 

PROBLEM:

 The display on the 

Computer (1)

 does not turn on.

          1) 

SOLUTION:

 Remove the 

Computer (1)

 and verify that the wires from the 

Computer (1)

 are

               properly connected to the wires of the 

Handlebar Post (79)

.

 
3. 

PROBLEM:

 Not displaying/inconsistent/erratic heart rate readings

          1) 

SOLUTION:

 Always hold onto the 

Hand Pulse (81)

 with both hands. Maintain moderate

               pressure when holding onto the 

Hand Pulse (81)

.

           2) 

SOLUTION: 

Make sure the wire connections for the 

Pulse Wires (80)

.

           3) 

SOLUTION:

 Wipe your excess moisture off your hands.

 
4. 

PROBLEM: 

The bike makes a squeaking noise when in use.

          1) 

SOLUTION:

 The bolts may be loose on the spin bike. Inspect all of the bolts and tighten

               any loose bolts.
 

MAINTENANCE

          1. The bike can be cleaned with a soft clean damp cloth.
          2. 

Do not

use abrasives or solvents on the plastic parts.

          3. Wipe your perspiration off the bike after each use.
          4. Be careful not to get excessive moisture on the Console display as this might cause an
              electrical hazard or the electronics to fail.
          5. Keep the bike, especially the computer console out of direct sunlight to prevent screen
              damage.
          6. Be sure all assembly bolts, nuts, screws, and pedals on the machine are thoroughly tightened
              prior to use. Tighten any loose parts.