7. Daily Inspection and Maintenance
At the start of each work day (or 8 hour shift), an
ATB 42/50 qualified operator must perform the
Daily Inspection and Maintenance as listed in the
table below.
The purpose of the Daily Inspection and
Maintenance is to keep the ATB 42/50 in proper
working condition and to detect signs of
malfunction at the earliest possible time.
The ATB 42/50 should be in the STOWED
POSITION and the Master Key Switch set to
OFF before you begin this inspection.
Defective parts and/or equipment malfunctions
jeopardize the safety of the operator and other
personnel, and can cause damage to the
machine.
DO NOT operate an ATB 42/50 that is known
to be damaged or malfunctioning.
Repair all equipment damage or malfunctions,
before placing the ATB 42/50 into service.
ATB 42/50 – 0161987
page 7 - 1
Item
Service Required
Engine fuel level
Look to see that the fuel tank is full
Fuel tank cap
Check to see that the cap is tight
Engine oil level
Check oil level (between dipstick lines)
Fuel leaks
Visually inspect (hoses and connections)
Engine coolant level
Check fluid level and radiator hoses
Wiring harnesses
Visually inspect (installation, condition)
Battery terminals
Visually inspect (no corrosion)
Battery fluid level
Check fluid level (1/4" or 6 mm below filler neck)
Hydraulic oil level
Visually inspect level (between lines on gauge)
Hydraulic oil leaks
Visually inspect (hoses, tubes)
Tires
Visually inspect (condition)
Bolts and fasteners
Visually inspect (condition)
Structural damage and welds
Visually inspect (weld cracks, dents)
Lanyard anchor points
Visually inspect (condition)
Platform gravity gate
Check condition and operation
Platform swinging gate (option)
Check condition and operation
Platform guardrails
Visually inspect (condition)
Flashing lights (option)
Visually inspect (operation)
Air filter
Check condition (gauge)
Charging system
Visually inspect (gauge)
Ground control switches and alarms
Actuate and inspect for proper operation
Level sensor
Check operation
Emergency power
Check operation (causes correct motion)
Platform control box switches and
alarms
Actuate and inspect for proper operation
Ground Fault Circuit Interrupt
Check operation
Platform work lights (option)
Check operation
Slide pads (ATB 50 only)
Visually inspect for installation and boom wear marks
Axle unlocked alarm, tipover hazard light
Actuate and inspect for proper operation
Placards and decals
Visually inspect (installation, condition)
■
Daily Inspection and Maintenance Table
DANGER
