92
Snorkel International, LLC
2009 Roseport Road
Elwood, KS 66024
Model: Snorkel SR5719
Part Number: 159-0074-000
Version: Stage 5 / Open Cab
a.
GENERAL INFORMATION
Park the machine on level ground.
The work area must be clean and dry.
Maintenance, repair and adjustment operations must be carried out by qualified and skilled
personnel with the machine switched off.
It is forbidden to carry out maintenance when the machine is moving.
Carry out the maintenance respecting the intervention times indicated in this manual; damaged or
worn components must be promptly repaired or replaced.
Always keep the machine clean from debris and eliminate grease deposits or oil deposits.
Disconnect the battery cables if it is necessary to perform arc welding on the machine or work on
the electrical system.
If electric arc welding must be performed, disconnect the transmission control unit inside the
general electrical box.
If arc welding must be performed, connect the mass of the welding machine to a point that is in
direct contact with the area to be welded, always avoiding the interposition of reciprocal sliding
parts such as joints, bearings and hydraulic cylinders.
Wear protective glasses and mask when using compressed air for cleaning.Do not direct the jet
towards the skin or the eyes.
Use gloves and glasses when handling detergent liquids and/or lubricants.
After maintenance and before enabling the machine, make sure that any safety devices removed
previously have been restored.
If the machine must be lifted, make sure it is supported on a solid and safe base.
When operating under mobile lifted parts (e.g. telescopic boom), block the hydraulic cylinder
movements with the spacers and rest them on top of safe and strong supports.
Summary of Contents for SR5719
Page 159: ......
