Lit. No. 85757, Rev. 01
14
November 15, 2018
6. Plug the boom hose into the pump output
fi
tting
located below the shut-off valve.
Hitch
Pin
Hairpin
Cotter
Wet Boom
Drop Mount
4. Secure the unit in place with supplied
3/8" x 1-1/2" hex cap screws, 3/8"
fl
at washers,
and 3/8" locknuts.
If the mounting holes are not
directly over the truck box supports, the truck
bed must be braced to the frame to prevent
buckling or deforming the truck bed.
NOTE: Pay special attention when drilling or
clamping dissimilar metals to aluminum bodies.
Galvanic corrosion can occur if not handled
properly. Contact vehicle manufacturer for
recommended attachment practices.
5. Install the boom assembly with light duty receiver
mount into wet boom drop mount that was
installed in Step 1.
INSTALLATION INSTRUCTIONS
Boom
Hose
Shut-Off
Valve
Pump Output
Fitting
Connect boom hose to
pump output fitting.
3/8" x 1-1/2"
Hex Cap Screw
3/8" Flat
Washer
3/8"
Locknut
Frame Spacer
Built to Fit
Summary of Contents for Accuspray VSS-1000-1
Page 2: ......
Page 4: ...Lit No 85757 Rev 01 4 November 15 2018...
Page 6: ...Lit No 85757 Rev 01 6 November 15 2018...
