Lit. No. 85757, Rev. 01
15
November 15, 2018
25A
Battery
Double Female
3" Jumper
ON/OFF
Switch
Rubber
Switch
Boot
Wiring
Harness
Fuse Holder
25A Fuse Circuit Breaker
3/8" Ring
Terminal
ELECTRICAL SYSTEM – WIRING INSTRUCTIONS
ELECTRICAL SYSTEM
WIRING INSTRUCTIONS
1. Install switch at desired location.
2. Run spreader/vehicle harness from the rear of
vehicle to switch area. Attach the female spade
red wire to the switch. Leave the black wire for
Step 5.
3. Route the power harness from the battery to the
switch/control.
4. Attach the red lead to the POSITIVE (+)
side of the battery and the black lead to the
NEGATIVE (–) side of the battery.
5. Attach the female spade red wire on switch
terminal. Using a 3" double female black wire
jumper, attach the black wire from the power
harness to the black wire of the vehicle harness.
6. Install rubber weatherproof boot on switch before
fi
nishing installation.
7. Insert dielectric grease on terminals of SAE plug
at rear of vehicle.
Summary of Contents for Accuspray VSS-1000-1
Page 2: ......
Page 4: ...Lit No 85757 Rev 01 4 November 15 2018...
Page 6: ...Lit No 85757 Rev 01 6 November 15 2018...