Lit. No. 74256, Rev. 02
12
February 15, 2020
MOUNTING THE SPREADER
4. Install the chute/de
fl
ector assembly to the spinner
assembly using the four 5/16" x 1-1/2" tapping
screws and 5/16" locknuts in the supplied
hardware kit to complete the drive assembly.
5. Mount the drive assembly to the spreader using
the 1/2" x 17-5/8" bent pin and secure it with the
2-3/8" hairpin cotter. Ensure that the bent pin
passes through the small center mounting tab on
the auger drive enclosure.
6. Slide the spreader forward until the de
fl
ector/chute
assembly makes contact with the vehicle. Then
slide spreader back approximately 1" to allow
proper clearance.
7. Once the spreader is positioned front to back in
the vehicle bed, center it left to right.
8. Looking at the inside corners of the spreader
frame, you will notice four holes in the bottom of
the frame. Using a paint pen or similar marking
device, mark the hole locations on the vehicle bed.
If mounting holes cannot be drilled in the
marked locations,
install the mounting bars from
the optional UTV mounting kit to the spreader
frame using the supplied 1/2" x 1-1/2" carriage
bolts and 1/2" locknuts. Use the existing holes in
the mounting bars to mark drilling locations on the
vehicle bed.
MOUNTING THE SPREADER
NOTE: Periodically throughout the snow and ice
control season, verify that mounting devices are
secure.
1. Remove the tailgate from the UTV bed.
2. Load the spreader onto the UTV bed.
3. Assemble the chute to the de
fl
ector using the
four 1/4" x 3/4" serrated
fl
ange cap screws and
1/4" locknuts in the supplied hardware kit.
WARNING
Spreader shall be bolted to vehicle frame.
Do not rely on the tie-down chains or straps
alone to hold spreader in vehicle.
CAUTION
Before lifting, verify that hopper is empty of
material. The lifting device must be able to
support the spreader's weight.
De
fl
ector
Chute
De
fl
ector
Spinner
Assembly
Summary of Contents for V-Pro 32200
Page 2: ......
